ETRTO Hookless Rule
Always verify both your tire sidewall and rim manufacturer limits. Hookless rims are strictly capped at 72.5 PSI (5.0 BAR) under ETRTO standards.
CYCLING & FITNESS · ROAD, GRAVEL, MTB, TUBELESS & HOOKLESS PSI/BAR
Calculate optimal front and rear bike tire pressure in PSI and BAR for road, gravel, MTB, tubeless, and hookless wheels based on total weight, tire width, and surface.
BALLPARK TIRE PRESSURE REFERENCE
| Bike Type | Typical Tire Width | Tubeless Front / Rear (PSI) | Tubeless Front / Rear (BAR) |
|---|---|---|---|
| Road (Race / All-Road) | 28mm – 30mm | 66 – 74 PSI | 4.5 – 5.1 BAR |
| Endurance Road | 32mm – 35mm | 52 – 62 PSI | 3.6 – 4.3 BAR |
| Gravel | 40mm – 45mm | 32 – 42 PSI | 2.2 – 2.9 BAR |
| XC / Trail MTB | 2.25" – 2.4" (57–61mm) | 20 – 26 PSI | 1.4 – 1.8 BAR |
Always verify both your tire sidewall and rim manufacturer limits. Hookless rims are strictly capped at 72.5 PSI (5.0 BAR) under ETRTO standards.
Check out Running Pace Calculator, Unit Converter, or Calorie Calculator.
On almost every bicycle, 54% to 60% of your combined weight sits over the rear wheel. Running the front tire 4%–10% lower than the rear gives both tires equal deflection, improving cornering grip and hand comfort.
Under ETRTO safety standards, hookless road and gravel rims have a strict maximum pressure of 72.5 PSI (5.0 BAR). Exceeding this limit can blow the tire off the rim. If you need higher pressure for your weight, switch to a wider tire (30mm–32mm+).
Yes, up to a point. Over-inflated tires bounce off micro-imperfections in asphalt, wasting forward energy (impedance loss). Modern 28mm–32mm road tires typically roll fastest between 60 and 80 PSI depending on system weight.
Tubeless setups eliminate pinch flats ("snakebites") and reduce casing friction, allowing you to safely run roughly 8%–12% lower pressure than standard butyl inner tubes.
Yes. Dropping 3–5 PSI (0.2–0.35 BAR) in wet conditions enlarges the tire contact patch for noticeably better braking and cornering traction on slick pavement or roots.
Use the actual measured width on your rim if you know it. A 28mm tire mounted on a wide modern 25mm internal rim often measures 30mm–31mm, which calls for ~8–10 PSI less than a true 28mm tire.